Car Diagnostic Tool FAQ--UOBD2

Help you to be a car master

How to use EUCLEIA TabScan S7 Reset EPB for Audi A8 2011

posted by Chasen on Aug 17, 2018 under Car Diagnostic Tool
tags: EUCLEIA TabScan S7

Here comes the guide on how to reset EPB for Audi A8 2011 by EUCLEIA TabScan S7.Hope it helps! Vehicle Information: Audi A8 2011 Manufacturer:Audi AG Neckarsulm VIN:WAURGB4H3CN0**** Type:A8L 3.0 TFSI quattro

Products for Operation: EUCLEIA TabScan S7 EUCLEIA TabScan S8 Procedures: Connect EUCLEIA TabScan S7 to vehicle and enter the “Service” menu to select “EPB Reset”

Select “Audi”-->”A8”

Select “A8(D3)”

Select “Replacement of brake pads” According to notes to release handbrake, then click “Yes”, at this time the rear brake pump motor will be heard for a few seconds to be retracted. After the retraction is completed, install the new brake pad according to the notification, then click “ok” The brake pump is released,please wait...

Lease replace brake pad for the two rear wheels! At this time rear brake pump will ring for few seconds, after the branch pump is released , click ok.

Replace brake pad success!

All operation completed, quite system, press electrical handbrake button to make handbrake work, reset EPB completed. Please exit the system,turn off and then turn on the ignition switch,completed.

Notes: Please do remember release the handbrake once Reset EPB. Article from EUCLEIA TabScan S7 S8 Tech,How to use EUCLEIA TabScan S7 Reset EPB for Audi A8 2011 

2 visits |0 Comments|Reply

There are no comments on this post

Write a New Comment on How to use EUCLEIA TabScan S7 Reset EPB for Audi A8 2011

Please Log In or Register to post comments.